Afikim Superlight SL-3 User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 26
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
11
8. THROTTLE POTENTIOMETER
The throttle controls both the speed and the direction of the scooter. Pushing the throttle in one
direction the scooter moves forward and pushing in the other the scooter moves reverse
Usually Forward is on the right hand
and Reverse on the left hand. How can
we reverse them without loosing
performances?
The throttle potentiometer is connected to Front board
by one six –pin connector plugged into J4 header
located on front board.
Reverse Blue and Brown wires. In this case depressing
the throttle with the left hand will select forward and
the reverse direction will be selected using the right
hand. Change the label of the for front and back !!
Is the potentiometer correct
calibrated?
Turn the power off.
Unplug the connector inserted in the header J4 located
on the front board.
Without depressing the throttle take the following
resistance readings:
- 1. Blue and Green
- 2. Green and Brown
- 3. Blue and Brown
The value of the potentiometer resistance may
range between 4.8Kohm and 5.2Kohm.
1 You should see 2400 – 2600 ohm
2 You should see 2400 –2600 ohm
3 You should see 4800 –5400 ohm
If the issues 1 and 2 have as result almost the same
values then the potentiometer may be correctly
centered within the controller’s neutral dead-band.
If a voltage reading is preferred turn the power on
and connect a voltmeter. Take three successive
readings. The red probe is pushed first into
terminal 2 of the J4 (Green wire) then into
terminal 1 (blue wire) and finally into terminal 3
(brown wire).
The black probe is pushed into terminal 4 of the
same connector J4 (GND).
Without depressing the throttle the following
readings should appears:
Terminals Value Front board
header
1 and 4 About 4.5V J4
2 and 4 About 2.5V+/-
100mV
J4
3 and 4 About 0.4V J4
The Status led indicator indicates
throttle fault
Perform throttle potentiometer test as describe above.
The goal of the test is to find out wires that are short-
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comments to this Manuals

No comments