Afikim Superlight SL-3 User Manual download pdf (Page 8)

4. LOW / HIGH SPEED CONTROL

The switch selects the driving mode (maximum speed limited at 60% or no limit)

High speed mode = the switch’s contacts are closed and the lamp illuminates

Low speed mode = The switch’s contacts are opened and the lamp is turned off.

The scooter does not travel at full speed and

the battery condition is good

1.Check connections of the switch with the Front

board. The connections must fit the following table:

Switch 1A Black Six circuits plug pin- 6

Switch 1 White Six circuits plug pin-5

Switch 1B Red Six circuits plug pin-4

2.Check cable that connect the Controller with the

Front board; check the continuity of wire that runs

between 8-8 each connector.

4. Replace the Front board

5. Replace the Controller

Turning the switch into Fast position blows

the fuse F1 located on the Front board

Red wire is reversed with White wire

The switch is working in reverse way Red wire is reversed with Black wire

Indifferent how the switch is set the lamp

glows continuously

Black wire is reversed with White wire

5. CHARGING

Indifferent which position is selected for Key Switch the system automatically will detect if the

charger outlet is plugged into the vehicle’s charging socket and the panel display is shut off.

The drive and lights functions are not allowed.

The charging current is routed via the controller, scooter’s power cord, the sixteen wires cable,

Front board and the Charging board adapter. The charging circuit is protected by a manually

resettable 4Amp circuit breaker. The charging average time may be about 10 hours.

1.Check circuit breaker status. Take a volt

reading from one of the metal tabs on the bottom

of the circuit breaker to the most negative

battery terminal (GND). If either of the readings

is different than the total battery voltage reset or

replace the fuse.

2.Check the connections between Charging

Adapter board and Front board

T1 RED T1

T2 BLUE T2

T3 BLACK T3

AC power is plugged in and the charger DC

outlet is connected to the scooter’s socket but the

charger’s display flashes informing the battery

side is not connected

3.Charging socket damaged.

Replace the Charging Adapter board

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Comments to this Manuals

No comments

Afikim Superlight SL-3 User Manual Page 8

Comments to this Manuals